Accessories & gifts
Squeegee Stems
Give your wheels a tint shop detail with four miniature squeegee valve stem caps.
Explore productFilmHub products
Accessories & gifts
Give your wheels a tint shop detail with four miniature squeegee valve stem caps.
Explore productInstallation additives
A pre-measured 1 fl oz dose of TackStop for one US gallon of your usual slip solution. Carry a shot in your tool pouch and mix it when you need it.
Explore productPrep & cleaning
Big panes don’t need to mean endless scrubbing. Slide two fingers through EverScrub’s center slot and put its larger cleaning surface to work on flat glass, windshields, and back glass.
Explore productPrep & cleaning
Keep the back-glass handle you already use. Swap the disposable pad for a reusable EverScrub pad, reach into the rear window, and get the glass prepped for the next install.
Explore productPrep & cleaning
Put the reach of your Bulldozer to work with a larger reusable scrub pad. Cover more back glass per pass, rinse it clean, and have it ready for the next car.
Explore productAccessories & gifts
Leave the gallon jug upright and pump out what you need. This screw-on dispenser makes it easier to refill your mix without tipping a full jug over a measuring cup.
Explore productCutting & edge control
Stop eyeballing every edge. MicroEdge gives you a 0.5 mm reference for a tight, consistent light gap from pane to pane.
Explore productInstallation additives
Hot glass flashes off your slip mix. The film grabs before you’re lined up, and now you’re fighting the install. TackStop slows that water loss so you have more time to position, adjust, and squeegee.
Explore productPrep & cleaning
Prep the glass, work through adhesive, rinse, and go again. EverScrub replaces disposable scrub pads with a reusable handled TPU scrubber that fits right into your usual prep routine.
Explore productCutting & edge control
Cut straight from the film box without hauling out a film handler. Snap together the 12-inch sections, set your width, and guide your blade along the cut.
Explore productAccessories & gifts
The one tinter in the shop who’s always ready to kick back. Stick this mini buddy to your metal tool cart, pose his legs, and give the workspace a little personality.
Explore productShop & heat tools
Blade holders, knives, Sharpies—keep them by the plotter instead of hunting around the shop. Blade Dock gives your cutting tools a dedicated spot in the upper tray.
Explore productFilm handling
Film walking on the handler while you cut? These pointed shims take up the gap between the roll and the handler ears, with an easier-to-seat profile.
Explore productFilm handling
Keep the roll from walking while you cut. These shims fill the gap between the film and the handler ears so you can get on with cutting instead of nudging the roll back into place.
Explore productCutting & edge control
Give decorative film an even picture-frame reveal without fighting an improvised guide. Pick your gap and follow Border Buddy around the pane.
Explore productShop & heat tools
Give your torch tank a steady place on the cart. BlazeBase 2.0 wraps it in a flexible TPU stand, with extra legs and a magnetic base for suitable metal surfaces.
Explore product